GE OEC 6600 Features:

• Designed For Extremity Imaging
• 6″ Dual-Mode Image Intensifier
• Dual Monitor Workstation
• Rotating Anode X-Ray Tube
• 64-400 Image Storage
• Last Image Hold
• 512 x 512 Resolution
• Standard CRT Monitors
• Parts Compatibility w/ OEC 9600
• Edge Enhancement
• No Option for Built in Laser Aimer
• Power: 40-80 kVp
• 3.5 Floppy Drive
• 27″ x 27″ Footprint

Dimensions:

• Base: 64.25 in (H) x 27.25 in (W) x 27.25 in (D)
• Weight: Approximately 250 Lbs

Transport Position:

• Height: 64.25 in
• Minimum width: 31.75 in
• Minimum depth: 30.25 in

X-Ray Tube:

• Fixed anode, tungsten filament
• Focal spot: 0.25 x 0.25 mm
• Target angle: 13.5°
• Beam quality minimum: HVL 2.6 mm Al at 70 kV

1. Run serial number with OEM for necessary upgrades, recalls, and revisions (software and firmware included)
2. Verify presence, function, and performance of internal components including, but not limited to: High voltage x-ray generator, High voltage cables, X-ray tube, Image intensifier, Vertical lift assembly, Steering mechanism, Power supplies, and Monitor displays
3. Repair, rebuild, or replace any internal components listed above that do not meet OEM specifications
4. Perform complete system disassembly
5. Disinfect all components
6. Sand and repaint all previously painted surfaces using a 4-coat process as performed by OEM
7. Reassemble refurbished components
8. Inspect and replace wiring harnesses as necessary
9. Lubricate all bearings and replace as necessary
10. Clean and calibrate all locking and braking systems
11. Inspect, clean, and lubricate high voltage cables
12. Install new batteries
13. Calibrate image quality to ensure optimum performance
14. Calibrate all other systems according to OEM specifications
15. Perform comprehensive manufacturer PM service prior to staging
16. Configure system to customer’s specified parameters
17. Stage system for optimum performance and reliability
18. Label machine and components to specified requirement